Ruijie RG-S29 Series

Command Reference MSTP Commands
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
N/A
Command
Mode
Interface configuration mode
Usage Guide
If you want to BPDU TUNNEL globally, enable BPDU TUNNEL on the interface first.
Configuration
Examples
The following example enables BPDU TUNNEL on the interface.
Ruijie(config-if-interface-id)# l2protocol-tunnel stp enable
Ruijie(config-if-interface-id)# show l2protocol-tunnel stp
L2protocol-tunnel: stp Enable
L2protocol-tunnel destination mac address: 01d0.f800.0005
GigabitEthernet 0/1 l2protocol-tunnel stp enable
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
9.9 l2protocol-tunnel stp tunnel-dmac
Use this command to configure the STP address for transparent transmission through BPDU
TUNNEL. Use the no form of this command to restore the default setting.
l2protocol-tunnel stp tunnel-dmac mac-address
no l2protocol-tunnel stp tunnel-dmac
Parameter
Description
Parameter
Description
mac-address
The STP address for transparent transmission.
Defaults
The defualt is 01d0.f800.0005.
Command
Mode
Global configuration mode