Ruijie RG-S29 Series

Command Reference ERPS Commands
WTR Time : 5 minutes
Current Ring State : Idle
Ruijie# show erps raps_vlan 4093 sub-ring
R-APS VLAN: 4093
Sub-Ring R-APS VLANs TC Propagation State
------------------- ---------------------
100 Enable
200 Enable
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
13.9 state enable
Use this command to enable/disable the specified R-APS ring.
state enable
no state enable
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
Disabled
Command
Mode
EPRS configuration mode.
Usage Guide
Only after the global ERPS protocol and the ERPS protocol of the specified ring are both enabled, the
ERPS protocol of the specified ring will begin truly running.
Configuration
Examples
The following example enables the specified ERPS ring:
#Enter the privileged EXEC mode.
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
#Configure the link mode of the Ethernet ring port and the default VLAN.
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-if)# switchport mode trunk
Ruijie(config-if)# exit