Ruijie RG-S29 Series

Configuration Guide AAA Commands
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
1.20 aaa log rate-limit
Use this command to set the rate of printing the syslog informing AAA authentication success.
Use the no form of this command to restore the default printing rate.
aaa log rate-limit num
no aaa log rate-limit
Parameter
Description
Parameter
Description
num
The number of syslog entries printed per second. The range is from
0 to 65,535.
0 indicates the printing rate is not limited.
Defaults
The default is 5.
Command
Mode
Global configuration mode
Usage Guide
Too much printing may flood the screen or even reduce device performance. In this case, use this
command to adjust the printing rate.
Configuration
Examples
The following example sets the rate of printing the syslog informing AAA authentication success to
10.
Ruijie(config)# aaa log rate-limit 10
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
1.21 aaa new-model
Use this command to enable the RGOS AAA security service.
Use the no form of this command to restore the default setting.
aaa new-model
no aaa new-model