Configuration Guide RADIUS Commands
response packet from the Radius server within the specified time, the
Radius server is considered to be unreachable. The value is in the
range from 1 to 120 in the unit of seconds.
Configures the successive timeout times. When sending a request
from the device to the Radius server times out for the specified times,
the device considers that the Radius server is unreachable. The
value is in the range from 1 to 100 in the unit of seconds.
The default time seconds is 60 and tries number is 10.
Global configuration mode
If a Radius server meets the timeout and timeout times at the same time, it is considered to be
unreachable. This command is used to adjust the parameter conditions of timeout and timeout times.
The following example sets the timeout to 120 seconds and timeout times to 20.
Ruijie(config)# radius-server dead-criteria time 120 tries 20
Defines the RADIUS security server.
Defines the duration when a device stops
sending any requests to an unreachable
Radius server.
Defines the timeout for the packet
re-transmission.
2.15 radius-server deadtime
Use this command to configure the duration when a device stops sending any requests to an
unreachable Radius server.
Use the no form of this command to restore the default setting.
radius-server deadtime minutes
no radius-server deadtime
Defines the duration in minutes when the device stops sending any
requests to the unreachable Radius server. The value is in the range
from 1 to 1,440 in the unit of minutes.
To Next Page
Loading...
Need help?
General