Appendix 3: VDRPARAMS.INI File, Rev. 1.2
VDR-100G3/G3S Installation Manual 18/01/2009
4
A3.5 Audio Parameters
Parameter Typical
Value
Remarks
Blocks 60 number of capture intervals per file
ChannelEnabled1 1 0=disabled; 1=enabled; default=1
ChannelEnabled2 1 0=disabled; 1=enabled; default=1
ChannelEnabled3 1 0=disabled; 1=enabled; default=1
ChannelEnabled4 1 0=disabled; 1=enabled; default=1
ChannelEnabled5 0 0=disabled; 1=enabled; default=0
ChannelEnabled6 0 0=disabled; 1=enabled; default=0
ChannelEnabled7 0 0=disabled; 1=enabled; default=0
ChannelEnabled8 0 0=disabled; 1=enabled; default=0
numOutputChannels 4
OutputChannel1 1 Use comma if 2 channels are mixed, i.e. 1,2
OutputChannel2 2
OutputChannel3 3
OutputChannel4 4
OutputChannel5 5
OutputChannel6 6
OutputChannel7 7
OutputChannel8 8
numVHFChannels 1 default is 1
VHF-Channel1 1 default is 1
VHF-Channel2 5 default is 5
MikesOnMixer1 2 default is 2
MikesOnMixer2 2 default is 2
MikesOnMixer3 2 default is 2
MikesOnMixer4 0 default is 0
MikesOnMixer5 0 default is 0
MikesOnMixer6 0 default is 0
MikesOnMixer7 0 default is 0
DetectionThreshold1 500 test signal RMS must exceed this to be detected
DetectionThreshold2 500 test signal RMS must exceed this to be detected
DetectionThreshold3 500 test signal RMS must exceed this to be detected
DetectionThreshold4 500 test signal RMS must exceed this to be detected
DetectionThreshold5 500 test signal RMS must exceed this to be detected
DetectionThreshold6 500 test signal RMS must exceed this to be detected
ChirpLength 30 mike self-test signal length, in ms (100 ms max)
MikeRetryInterval 3600 in seconds
MaxMikeRetrys 11 retry this many times before declaring failure
Table A3- 5 - Audio Parameters
The number of channels sampled by the VDR-100G3 is set in the NumOutputChannels field of
the INI file. The system will activate the first N input channels for which the ChannelEnabled field
is set to 1. The gain for each channel is set at the factory.
To Next Page
Loading...