5 OPERATION
5.12 MHL360 E
Engaging the starter
►
If the preheat indicator (115/59) does not
light up any more, press the start/stop
(115/31) button briefly.
The diesel engine starts and automatically
goes to low idle speed. The braking pres-
sure indicators (114/15), battery charge
control (114/16) and engine oil pressure
(114/17) must go out.
If the low idle speed is not reached after 5
seconds, the controller switches off the
diesel engine. Repeat the starting opera-
tion with the start/stop button (115/31).
Risk of machine damage.
- Wait at least 30 seconds before
repeating a starting operation.
- After starting, slowly warm up the
loading machine. Only then
switch to full power.
No starting operation
If the start/stop button (115/31) is pressed, but
no starting operation is triggered, it may be
deactivated.
h Chapter 5.21 Monitoring the machine dur-
ing operation
F
09 :43 11 .03. 2 011
MH LX X X / XXX X
18 00 U PM
0 5 1 0 15 20 2 5
95°C 7 5°C
0 ½ 1
9 %
120 0
15 16 17
BSB50587
34
11 14
23
Fig. 114 Main control display
I
0
29
59
BSB50588
31
4
56 62
58 60
54
66
Fig. 115 Starting the diesel engine
To Next Page
Loading...
