Terex MHL360 E - Page 257

CARE AND MAINTENANCE 7
MHL360 E 7.37
7.7.2.3 Change the engine oil filter.
The engine oil filter must be replaced every
time the engine oil is changed:
►
Place a suitable container under the engine
oil filter.
►
Clean the outside of the engine oil filter
cartridge (279/1).
►
Loosen and unscrew the filter cartridge
(279/1) using a standard tool. Check that
the fastening stud is located securely in the
filter head.
►
Dispose of the filter cartridge (279/1) ac-
cording to regulations.
►
Check the condition of the filter head and
clean.
►
Fill the new filter with oil. Wet the sealing
ring with oil and tighten firmly by hand until
the seal is securely in place.
►
With one more half turn, tighten the filter
cartridge.
►
Only start the engine if it contains suffi-
cient oil.
h Chapter 7.7.2.1 Checking the engine oil
level
►
After a trial run, check the engine oil filter
for leaks.
BSB50022
1
Fig. 279 Engine oil filter