Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Separating
– Remove centre armrest (split) ⇒ page 84 .
– Remove bolt -1-.
– Separate centre armrests.
– Detach upper support trim -4-.
5 - Centre armrest (right-side)
Assembling
– Fit upper support trim -4-.
– Assemble centre armrest.
– Raise centre armrests (topmost position).
– Move the two centre armrests to the same position by adjust‐
ing half support -2- or -3-.
– Screw both half supports -2- and -3- together.
– Mark mutual positioning of half supports.
– Fold down centre armrests (lowest position). Position of both
centre armrests must be the same.
– If this is not the case, slacken off bolt -1-.
– Adjust mutual positions of half supports -2- and -3-.
– Repeat this adjustment procedure until position of centre armr‐
ests is the same in both top and bottom settings.
– Install centre armrest (split) ⇒ page 84 .
Tightening torque:
Bolted joints of half supports: 15 Nm
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
5. Front centre armrest (split) 91
To Next Page
Loading...
