Audi A8 2003 - Removing and Installing Lid for Cup Holder and Small Storage Compartment; Removing and Installing Frame for Cup Holder Unit with Small Storage Compartment Lid

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove extension for centre console ⇒ page 59 .
– Unscrew bolts -3- (6x). 2.5 Nm
– Take out small storage compartment -2- downwards.
1 - Extension for centre console
3.7 Removing and installing lid for cup hold‐
er and small storage compartment
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1410-
Lid for cup holder
– Remove cup holder unit with small storage compartment lid
-3- ⇒ page 61 .
– Carefully unclip trim for cup holder -2- from rear.
– When installing: Clip trim for cup holder -2- into mountings
-3-.
Lid for small storage compartment
– Remove cup holder unit with small storage compartment lid
-3- ⇒ page 61 .
– Carefully unclip trim for small storage compartment -4- from
rear.
– When installing: Clip trim for small storage compartment -4-
into mountings -5-.
1 - Cup holder unit with small storage compartment lid
3.8 Removing and installing frame for cup
holder unit with small storage compart‐
ment lid
Special tools and workshop equipment required
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
62 Rep. gr.68 - Interior equipment