Audi A8 2003 - Removing and Installing Mounting Plate for Control Units; Separating Rear Seat Adjustment with Memory Control Unit J522 from Mounting Plate

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.10 Removing and installing mounting plate
for control units
Note
♦ Seat adjustment control unit -4-: Connectors -1- and -10- right
seat, connectors -2- and -3- left seat.
♦ Control unit -6-: for right seat ventilation.
♦ Control unit -7-: for left seat ventilation.
♦ Removing
– Vehicles with centre console extension: Remove the centre
console extension ⇒ page 59 .
– Vehicles with no centre console extension: Remove the centre
section ⇒ page 341 .
– Unplug the connectors -1-, -2-, -3- and -10- at the seat adjust‐
ment control unit -4-.
– Unplug the connector -9- at the right seat ventilation control
unit -6-.
– Unplug the connector -8- at the left seat ventilation control unit
-7-.
– Lift out the mounting plate -5-.
♦ Installing
– Install the mounting plate -5- in the reverse order of removal.
3.11 Separating rear seat adjustment with
memory control unit -J522- from mount‐
ing plate
♦ Removing
– Vehicles with centre console extension: Remove the centre
console extension ⇒ page 59 .
– Vehicles with no centre console extension: Remove the centre
section ⇒ page 341 .
– Remove the mounting plate for control units ⇒ page 347 .
– Prise out the clips -1- (2x) and -7-.
– Take out the control unit -2-.
♦ Installing
– Press the control unit -2- into the mounting plate -8-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Electrically operated individual rear seats 347