Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6.21 Removing and installing grip moulding
Removing
– Remove the rear lid trim ⇒ Item 1 (page 269) .
– Remove the speed nuts -2- (8x).
– Detach the grip moulding -1-.
Installing
Install in reverse order. Pay attention to the following:
♦ Use new speed nuts (8x).
6.22 Removing and installing button to close
rear lid in luggage compartment -E406-
Removing
– Use a blunt flat screwdriver to carefully prise the button to
close rear lid ( -E406- ) -1- out of the frame -3-. To do so, apply
the flat screwdriver to the short sides of the rear lid close but‐
ton.
– Pull the rear lid close button out of the rear lid trim.
– Unplug the connector -2-.
Installing
Install in reverse order.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
6. Trim panels 271