Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2 - Velcro strips (2x)
3 - Fastening strips (2x)
4 - Fastener
5 - Plastic clips
6 - Awl -V.A.G 1636A-
7 - Padding
1.5 Removing head restraint guides
Note
For greater clarity, the head restraint guide -1- has been removed
in the illustration.
– Insert an upholstery needle or screwdriver -3- with a max.
width of 2 mm in the hole -4- (the hole -4- is located opposite
the fastener of the head restraint guide).
– Whilst levering the screwdriver -3- in the direction of arrow
-A- and pressing the retainer tab -2- in the direction of arrow
-B-, pull out the head restraint guide -1-.
1.6 Removing head restraint guides (con‐
venience seat)
♦ Removing
– Remove the head restraint ⇒ page 315 .
– Lift out the head restraint guides -2- (2x).
♦ Installing
– Install the head restraint guides -2- (2x) in the reverse order of
removal.
– Make sure the tabs -3- (4x) engage.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
366 Rep. gr.74 - Seat - padding, covers
To Next Page
Loading...
