Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Installing
– Make sure the head restraint guides with buttons are installed
on the left side in the direction of travel.
– Install the head restraint guide -2- in the reverse order of re‐
moval.
2.5 Removing and installing head restraint
cover and padding
– Remove the head restraint ⇒ page 337 .
– Use a screwdriver to prise out the fastening strips -2- (4x).
– Detach the cover and padding -1-.
– Take the padding -2- out of the cover -3-.
♦ Installing:
– Insert the padding -2- in the proper position in the cover -3-.
– Slide the head restraint mount -1- into the padding with cover.
– Press the fastening strips firmly into the guide slot (check by
pulling).
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
376 Rep. gr.74 - Seat - padding, covers
To Next Page
Loading...
