Audi A8 2003 - Removing and Installing Backrest Adjustment Motor

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Rivets (4x)
2 - Bolts (8x)
3 - Seat pan with seat cushion
extension motor
♦ Removing
– Remove the seat
⇒ page 282 .
– Attach the holder for
seat repair -VAS 6136-
to the engine and gear‐
box holder -VAS 6095- .
– Attach the front seat to
the holder for seat repair
-VAS 6136- .
– Remove the side trim on
the sill panel side
⇒ page 292 .
– Remove the side trim on
the tunnel side
⇒ page 293 .
– Remove the front trim
⇒ page 293 .
– Remove the holder for
the seat side trim panels
⇒ page 294 .
– Remove the backrest
⇒ page 288 .
– Remove the seat pan
cover and padding
⇒ page 360 .
– Remove the belt buckle
⇒ page 116 .
– Unfasten the wiring har‐
ness and unplug the
connectors from the
seat pan and the seat
cushion extension mo‐
tor.
– Drill out the rivets -1-
(4x).
– Replace the seat pan with seat cushion extension motor -3-.
♦ Installing
– Install in reverse order.
4 - Lower seat pan frame
5 - Upper seat pan frame
1.25 Removing and installing backrest adjustment motor
♦ Removing
– Remove the seat ⇒ page 282 .
– Attach the holder for seat repair -VAS 6136- to the engine and
gearbox holder -VAS 6095- .
– Attach the front seat to the holder for seat repair -VAS 6136- .
– Remove the side trim on the sill panel side ⇒ page 292 .
– Remove the side trim on the tunnel side ⇒ page 293 .
– Remove the front trim ⇒ page 293 .
– Remove the holder for the seat side trim panels ⇒ page 294 .
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
306 Rep. gr.72 - Seat frames