Audi A8 2003 - Removing and Installing Hinged Pocket Without Mount

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Hinged pocket with mount
♦ Removing
– Remove the door trim
⇒ page 189 .
– Remove the insulation
⇒ page 192 .
– Unscrew the bolts -3-
(5x).
– Unscrew the bolts -4-
(7x).
– Take out the hinged
pocket with mount -1- on
the front side of the door
trim -2-.
♦ Installing
– Install the hinged pocket
with mount -1- in the re‐
verse order of removal.
2 - Door trim
3 - Bolts (5x)
❑ Tightening torque 2 Nm.
4 - Bolts (7x)
❑ Tightening torque 2 Nm.
2.14 Removing and installing hinged pocket
without mount
♦ Removing
– Remove the door trim ⇒ page 189 .
– Remove the insulation ⇒ page 192 .
– Remove the hinged pocket with mount ⇒ page 196 .
– Use pliers to pull out the pins -1- (2x).
– Use a screwdriver to prise out the pins -4- (2x).
– Detach the hinged pocket -2- from the mount -3-.
♦ Installing
– Install the hinged pocket -2- in the reverse order of removal.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Rear door trim panels 197