Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Insert the clamping elements -1- with the bolts -2- screwed in
into the guide at the refrigerator box.
– Push down the clamping elements as far as they will go.
– Pull the refrigerator box towards the rear seat backrest and
push the clamping elements down as far as possible.
– Tighten the bolts.
– Fit the trim frame.
Tightening torque
Component
Nm
Clamping element to refrigerator box
4
1.3 Removing and installing thermostat
Removing
Note
All cable ties unfastened or severed on removal are to be re-at‐
tached in the same position on installation.
– Remove the refrigerator box ⇒ page 385 .
– Pull off the rotary knob -1- for the thermostat.
Note
♦
If stiff, use universal pliers to pull off the rotary knob.
♦
Wrap a cloth around the jaws of the pliers so as not to damage
the rotary knob.
– Unscrew the nut -1- and screw out the bolts -arrows-.
– Detach the trim -2- with the hinged cover for the refrigerator
box.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
386 Rep. gr.76 - Gas, water, electricity
To Next Page
Loading...
