Audi A8 2003 - Outer Floor Panel Anchorage Point; Removing and Installing Three-Point Seat Belt

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.2 Outer floor panel anchorage point
2.2.1 Removing and installing belt end fitting
1 - Front seat
2 - Belt end fitting
♦ Removing
– Move the front seat -1-
as far upwards and to
the rear as possible.
– Use a screwdriver to
prise out the holder -3-
and slide out the belt
end fitting -2- in arrow
direction.
♦ Installing
– Turn the webbing
through 180°.
– Position the belt end fit‐
ting -2- over the large
opening.
– Engage the belt end fit‐
ting -2- in direction op‐
posite to arrow.
3 - Holder
2.3 Removing and installing three-point seat
belt
Special tools and workshop equipment required
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Seat belts 107