Audi A8 2003 - Removing and Installing Rear Wheel Housing Trim; Removing and Installing D-Pillar Trim

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6.9 Removing and installing rear wheel housing trim
1 - Mount
2 - Wheel housing trim
♦ Removing
– Unfasten the wheel
housing trim -2- at the
clips -4- and -5-.
– Disengage the wheel
housing trim -2- from the
mount -1- and pull out
the wheel housing trim
-2-.
♦ Installing
– Install the wheel hous‐
ing trim in the reverse
order of removal.
WARNING
Make sure the trim is a
firm fit.
– Make sure the rubber
door seal is properly fit‐
ted over the wheel hous‐
ing trim.
3 - Mount
4 - Clip
5 - Clip
6.10 Removing and installing D-pillar trim
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
258 Rep. gr.70 - Trim, insulation