Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Turn the knurled wheel -3- of the air vent fully up.
– Above the bottom slat -2-, insert a jeweller's screwdriver -1- in
each of the two air vent clips.
– Alternately pull the left and right side of the air vent out of the
installation opening, leaving the jeweller's screwdrivers in po‐
sition.
Note
If necessary, use a hook -3438- to pull the air vent out of the
opening.
– Unplug the connector at the air vent.
Installing
Install in reverse order.
3.5 Removing and installing dash panel in‐
sert trim panel
Special tools and workshop equipment required
♦ Removal wedge - 3409-
♦ Hook -3438-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
214 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
