Audi A8 2003 - Removing and Installing Rear Vent (2-Zone Climate Control)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Open front centre console cup holder -1-.
– Take out cup holder insert -2-.
Installing
Install in reverse order of removal.
Tightening torque:
Front centre console cup holder to trim for centre console with
multimedia operating unit: 4 Nm
2.11 Removing and installing rear vent (2-
zone climate control)
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783/-
Removing
Removal is described for a rear vent (2-zone climate control)
without seat potentiometer.
The removal procedure with seat potentiometer is similar.
2.11.1 Removing storage compartment (rear)
– Switch off ignition.
– Pull storage compartment (rear) -1- out of centre console -2-.
3 - Trim for rear centre console
4 - Rear vent (2-zone climate control)
5 - Cigarette lighter (rear)
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Removing and installing centre console without extension 35