Audi A8 2003 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
8 Removing and installing knee airbag
Block diagram
♦ ⇒ „8.1 Removing and installing driver's knee airbag“,
page 149
♦ ⇒ „8.2 Removing and installing front passenger's knee airbag“,
page 150
♦ ⇒ „8.3 Removing and installing deformation element for driv‐
er's knee airbag“, page 152
♦ ⇒ „8.4 Removing and installing deformation element for front
passenger's knee airbag“, page 154
8.1 Removing and installing driver's knee
airbag
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783-
Removing
WARNING
♦ Heed the safety regulations for pyrotechnic components
⇒ page 94 .
♦ Heed the disposal regulations for pyrotechnic compo‐
nents ⇒ page 96 .
– With the ignition switched on, disconnect the battery earth wire
⇒ Electrical system; Rep. gr. 27 .
– Remove the driver's storage compartment ⇒ page 9 . Re‐
member that the knee airbag is attached to the storage com‐
partment.
– Unplug the knee airbag connector (yellow).
– To do so, pull the catch -2- in arrow direction and unplug the
connectors -1- and -3-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
8. Removing and installing knee airbag 149

Audi A8 2003 Specifications

General

Brand	Audi
Model	A8 2003
Category	Automobile
Language	English