Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
8 - Plug for coil connector
9 - Connector for airbag unit
❑ Mechanically encoded to prevent interchange
10 - Connector for multi-function steering wheel
11 - Connector for heated steering wheel
12 - Return ring with slip ring
13 - Coupling for heated steering wheel
14 - Coupling for airbag unit
4.3 Removing and installing airbag coil con‐
nector and return ring with slip ring -
F138-
Special tools and workshop equipment required
♦ Screwdriver T8 -T40056 A-
Note
♦
The return ring with slip ring must be removed and installed in
the centre position (wheels in straight-ahead position).
♦
The new return ring with slip ring is secured in the centre po‐
sition with a cable tie or shear ring.
Removing
– Move the adjustable steering column down as far as it will go
and pull out as far as the stop.
– Remove the steering wheel ⇒ page 126 .
– Remove the driver's storage compartment ⇒ page 9 .
Vehicles with mechanically adjustable steering column
– Slacken off the bolt -2-.
– Detach the handle -1-.
3 - Steering column trim
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
128 Rep. gr.69 - Passenger protection
To Next Page
Loading...
