Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unplug the connectors -1 ... 4-.
– Unplug the connectors -1- and -4-.
– Carefully pull the capillary tube -3- out of the refrigerator box
housing -arrow- and detach the thermostat -2-.
Installing
Install in reverse order, paying attention to the following:
Note
♦
Take care not to kink or damage the capillary tube.
♦
The thermostat must be replaced if the capillary tube is kinked
or damaged.
♦
Re-attach all cable ties in the same locations on installation.
– Slide the capillary tube -3- approx. 66 cm into the hole.
– Make sure the locator at the thermostat -2- engages in the hole
at the trim -1- -arrows-.
Tightening torques
Component
Nm
Thermostat to trim
12
Trim to housing
1.5
1.4 Removing and installing contact switch
for refrigerator box interior light
Removing
Note
All cable ties unfastened or severed on removal are to be re-at‐
tached in the same position on installation.
– Remove the refrigerator box ⇒ page 385 .
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Servicing refrigerator box 387
To Next Page
Loading...
