Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.2 Removing and installing airbag control
unit (J 234)
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1410/-
♦ Removing
WARNING
♦ Heed the safety regulations for pyrotechnic components
⇒ page 94 .
♦ Heed the disposal regulations for pyrotechnic compo‐
nents ⇒ page 96 .
– With the ignition switched on, disconnect the battery earth wire
⇒ Electrical system; Rep. gr. 27 .
– Remove the centre console ⇒ page 19 .
– Detach the insulation at the perforation.
– Open the catch -3- at the connector -4-.
– Unplug the connector -4-.
– Unscrew the nuts -2- (3x).
♦ Tightening torque 9 Nm.
– Detach the control unit -1-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Servicing airbag 119
To Next Page
Loading...
