Audi A8 2003 - Removing and Installing Backrest Holder; Seat Centre Section Holders

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
13 - Wiring harness
14 - Tab
15 - Bolt
❑ Tightening torque 55 Nm
16 - Tab
17 - Bolt
3.5 Removing and installing backrest holder
– Remove the seat pan ⇒ page 342 .
– Remove the backrest ⇒ page 343 .
– Unscrew the nuts -2- (4x). Tightening torque 8 Nm
– Detach the backrest holder -1-.
3 - Felt pad
3.6 Seat centre section holders
Seat centre section front holder
– Remove the seat centre section ⇒ page 341 .
– Unscrew the nuts -2- (2x). Tightening torque 4.5 Nm.
– Detach the seat centre section front holder -1-.
3 - Fastener
Seat centre section rear holder
– Remove the seat centre section ⇒ page 341 .
– Unscrew the nuts -4- (2x). Tightening torque 4.5 Nm.
– Detach the seat centre section rear holder -5-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
344 Rep. gr.72 - Seat frames