Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.8 Removing and installing window regula‐
tor switch module
♦ Removing
– Remove the door trim ⇒ page 176 .
– Remove the insulation ⇒ page 176 and ⇒ page 181 .
– Remove the armrest ⇒ page 182 .
– Use a screwdriver to prise out the window regulator switch
module -1- at the locations marked -2- (4x).
– Unplug the connector -3-.
♦ Installing
– Install the window regulator switch module -1- in the reverse
order of removal.
1.9 Dismantling armrest
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783/-
– Remove the door trim ⇒ page 176 .
– Remove the insulation ⇒ page 176 and ⇒ page 181 .
– Remove the armrest ⇒ page 182 .
– Unscrew the bolts -5- (2x).
♦ Tightening torque 2 Nm.
– Unscrew the bolt -4-.
♦ Tightening torque 2 Nm.
– Pull the front section -3- of the armrest -1- out of the
guide -2-.
– Push down the cover -6- to the rear.
♦ Installing
– Assemble the armrest in the reverse order of removal.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Front door trim panels 183
To Next Page
Loading...
