Audi A8 2003 - Removing and Installing Rear Outer Floor Panel Anchorage Point with Electrically Operated; Individual Seats; Centre Floor Panel Anchorage Points

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.8 Removing and installing rear outer floor
panel anchorage point with electrically
operated individual seats
– Remove the seat pan ⇒ page 342 .
– Thread the webbing -5- out of the webbing holder -4-.
– Disengage the webbing holder -4- at the lug -3-.
– Pull the webbing holder -4- forwards in arrow direction.
– Unscrew the nut -2-. Tightening torque 55 Nm.
– Take out the seat belt retainer -1-.
2.9 Centre floor panel anchorage points
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
114 Rep. gr.69 - Passenger protection