Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.3 Removing and installing centre console
Special tools and workshop
equipment required
♦ Removal wedge -3409-
♦ Protective cap -
VAS 6223/9-
♦ Radio release tool -
T10057-
Removing
Note
All cable ties unfastened or cut open on removal are to be re-
attached at the same location on installation.
– Move front seats to rearmost position and set backrests to 45°
position.
WARNING
Observe safety regulations for pyrotechnic components
⇒ page 94 .
– With ignition switched on, disconnect battery earth wire ⇒
Electrical system; Rep. gr. 27 .
– Remove airbag unit and steering wheel ⇒ page 123 .
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Removing and installing centre console without extension 19
To Next Page
Loading...
