Audi A8 2003 - Removing and Installing Centre Floor Panel Anchorage Points (Buckle) with Electrically Operated Individual Seats; Replacing Belt Buckle; Specific)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.10 Removing and installing centre floor
panel anchorage points (buckle) with
electrically operated individual seats
– Vehicles with no centre console extension: Remove the centre
section ⇒ page 341 .
– Vehicles with centre console extension: Remove the long cen‐
tre console ⇒ page 59 .
– Unscrew the bolt -2-. 35 Nm.
– Detach the belt buckle -1-.
2.11 Replacing belt buckle
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1331-
Removing:
– Remove the seat ⇒ page 282 .
– Unfasten the cable -4- at the clip -3-.
– Unfasten the cable tie -2-.
– Unplug the connector -5-.
– Unscrew the bolt -6-.
– Detach the belt buckle -1-.
Installing:
♦ Install in reverse order. Pay attention to the following when
doing so.
– Replace the buckle attachment bolt.
Tightening torque:
Component Nm
Bolt for buckle attachment 34
2.12 Replacing buckle for seat-occupied sen‐
sor for front passenger's airbag deacti‐
vation (country-specific)
Special tools and workshop equipment required
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
116 Rep. gr.69 - Passenger protection