Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Prise off securing clip -1-.
– Remove pins -2-. Use mandrel if necessary.
– Disengage stop -3- at top of carrier.
Installing
Install in reverse order of removal. Observe the following:
– Always renew securing clip following removal.
– Make sure carrier and padding fully engage.
4.5 Removing and installing carrier for cen‐
tre armrest
Removing
– Remove centre armrest ⇒ page 75 .
– Starting at bottom -arrow-, carefully prise cover -1- off padding
-2-.
– Take out cover.
– Press down retaining tabs -1-.
– At the same time, press carrier -2- in direction of -arrow- until
lugs of carrier are disengaged from guides of padding -3-.
– Take bracket with carrier out of padding.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
80 Rep. gr.68 - Interior equipment