Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.14 Removing and installing dash panel
Special tools and workshop
equipment required
♦ Removal lever -80-200-
♦ Removal wedge -3409-
♦ Hook -3438-
♦ Protective cap -
VAS 6223/9-
♦ Screwdriver T8 -T40056 A-
♦ Radio release tool -
T10057-
3.14.1 Removing
• The display unit for front information display and operating unit
control unit -J685- (MMI monitor) must be closed.
Note
All cable ties unfastened or severed on removal are to be re-at‐
tached in the same position on installation.
– Move the steering wheel down and to the rear as far as pos‐
sible, making use of the full range of the steering column
adjuster.
– Move the front seats to the rearmost position and set the
backrests to 45° position.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
224 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
