Audi A8 2003 - Removing and Installing Storage Compartment;Knee Bolster (Drivers Side)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.6 Removing and installing storage com‐
partment/knee bolster (driver's side)
Special tools and workshop equipment required
♦ Removal wedge -3409-
Removing
WARNING
Observe safety regulations for pyrotechnic components
⇒ page 94 .
– Vehicles with knee airbag: With ignition switched on, discon‐
nect battery earth wire ⇒ Electrical system; Rep. gr. 27 .
– Use screwdriver to prise off dash panel end trim (left-side)
-arrow-.
– Carefully separate trim panel -1- from dash panel using re‐
moval wedge -3409- -arrows-.
– Open coin holder.
– Slide trim for coin holder to left out of fastener -arrow- and
detach.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
10 Rep. gr.68 - Interior equipment