Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.2 Removing and installing cover and pad‐
ding for rear seat backrest
2.2.1 Separating cover and padding from backrest frame
1 - All-round fastening strips
2 - Side airbag
3 - Zip
4 - Protective cover for side air‐
bag
5 - Opening in padding
6 - Fastener
7 - Cover
♦ Removing
– Remove the rear seat
bench ⇒ page 333 .
– Remove the rear seat
backrest ⇒ page 334 .
– Remove the head re‐
straints ⇒ page 337 .
– Remove the head re‐
straint guides
⇒ page 375 .
– Use a screwdriver to
prise out the all-round
fastening strips -1-.
– Pull the lower cover -7-
over the fastener -6-.
– Fold over the cover -7-
in the area of the side
airbag -2-.
– Unfasten the zip -3- at
the protective cover for
the side airbag -4-.
– Pull out the protective
cover for the side airbag
-4- through the opening
in the padding -5-.
– Detach the cover and
padding from the back‐
rest frame.
♦ Installing
– Fit the cover and padding in the reverse order of removal.
– Fasten the zip at the protective cover for the side airbag using the Audi fastening tool for rear side airbag
-VAS 6273- .
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Rear seat covers and padding 373
To Next Page
Loading...
