Audi A8 2003 - Removing and Installing Hinged Pocket; Removing and Installing Filler Neck Compartment Lid;Rear Lid Release Switch

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.15 Removing and installing hinged pocket
♦ Removing
– Remove the door trim ⇒ page 176 .
– Remove the insulation ⇒ page 176 and ⇒ page 181 .
– Remove the hinged pocket with mount ⇒ page 185 .
– Use pliers to pull out the pins -1- (2x).
– Use a screwdriver to prise out the pins -4- (2x).
– Detach the hinged pocket -2- from the mount -3-.
♦ Installing
– Install the hinged pocket -2- in the reverse order of removal.
1.16 Removing and installing filler neck com‐
partment lid/rear lid release switch
♦ Removing
– Remove the door trim ⇒ page 176 .
– Remove the insulation ⇒ page 176 and ⇒ page 181 .
– Remove the hinged pocket with mount ⇒ page 185 .
– Unscrew the bolts -1- (2x).
– Detach the cover -4-.
– Prise out the switch -2- on the right side and detach the switch
-2-.
– Unplug the connector -3-.
♦ Installing
– Install the filler neck compartment lid/rear lid release switch in
the reverse order of removal.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Front door trim panels 187