Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.3 Removing and installing centre section
cover
♦ Removing
– Remove the centre section ⇒ page 341 .
– Use a screwdriver to prise out the all-round fastening strips
-3-.
– Detach the cover -1- from the centre section -2-.
♦ Installing:
– Fit the cover -1- in the reverse order of removal.
3.4 Removing head restraint guides
Note
For greater clarity, the head restraint guide -1- has been removed
in the illustration.
– Insert an upholstery needle or screwdriver -3- with a max.
width of 2 mm in the hole -4- (the hole -4- is located opposite
the fastener of the head restraint guide).
– Whilst levering the screwdriver -3- in the direction of arrow
-A- and pressing the retainer tab -2- in the direction of arrow
-B-, pull out the head restraint guide -1-.
3.5 Removing and installing head restraint
cover and padding
♦ Removing
– Remove the head restraint ⇒ page 358 .
– Use a screwdriver to prise out the fastening strips -2- (4x).
– Detach the cover and padding -1-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
382 Rep. gr.74 - Seat - padding, covers
To Next Page
Loading...
