Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Open the glove compartment.
– Starting from above the glove compartment, carefully separate
the trim panel -1- with switch module from the dash panel using
the removal wedge -3409- .
– Detach the trim panel with switch module in -arrow direction-.
Note
Take particular care when releasing the clip at the driver side end
of the trim panel.
– Unplug the connector.
– Remove the coin tray.
– Screw out the bolts -arrows-.
– Detach the trim panel -1- above the glove compartment.
Installing
Install in reverse order, paying attention to the following:
– When inserting the trim panel -1- with switch module, make
sure the two fasteners in the centre of the panel are inserted
between the dash panel and the monitor housing -arrows-.
Tightening torque:
Trim panel above glove compartment to dash panel: 2.5 Nm
3.8 Removing and installing left or right de‐
froster vent
Special tools and workshop equipment required
♦ Front end hook -3370-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
3. Dash panel 219
To Next Page
Loading...
