Audi A8 2003 - Removing and Installing Rear Lid Trim

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6.19 Removing and installing rear lid trim
1 - Rear lid trim
♦ Removing
– Detach the lock cover
-4-.
– Remove the luggage
compartment light -11-
⇒ Electrical system;
Rep. gr. 96 .
– Remove the button to
close rear lid in luggage
compartment ( -E406- )
-3- ⇒ page 271 .
– Remove the box for the
tool kit and hazard warn‐
ing triangle -5-
⇒ page 268 .
– Screw the bolts -7- out
of the grip mouldings (2x
per moulding).
USA only
– Remove the emergency
release handle
⇒ page 270 .
All vehicles (continued)
– Unfasten the rear lid trim
-1- at the clips -10- (12x)
from underneath.
– Detach the rear lid trim
-1-.
♦ Installing
Install in reverse order. Pay at‐
tention to the following:
♦ Replace damaged clips
-10-.
♦ Before fitting the rear lid
trim, make sure the clips
-10- are correctly posi‐
tioned.
2 - Frame
♦ Removing
– Remove the button to close rear lid in luggage compartment ( -E406- ) -3- ⇒ page 271 .
– Unclip the frame on the back at the top.
– Take the frame out of the rear lid trim opening.
♦ Installing
Install in reverse order.
3 - Button to close rear lid in luggage compartment -E406- (optional)
❑ Removing and installing ⇒ page 271
❑ Assignment ⇒ Parts catalogue
4 - Lock cover
❑ Detach lock cover to remove.
❑ On installation, ensure proper engagement with lock.
5 - Box for tool kit and hazard warning triangle
❑ Removing and installing ⇒ page 268
6 - Cover
❑ 5x
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
6. Trim panels 269