Audi A8 2003 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Open glove box.
– Starting from above glove box, carefully separate trim panel
-1- with switch module from dash panel using removal wedge
-3409- .
Note
Take particular care when unfastening clip at end of trim panel
closest to driver.
– Unplug electrical connector.
– Unscrew driver's storage compartment -arrows-.
– Unplug electrical connectors.
– On vehicles with knee airbag: Pull catch -2- in direction of ar‐
row and unplug electrical connectors -1- and -3-.
Installing
Installation is carried out in reverse order; note the following:
– When fitting trim panel -1- with switch panel make sure both
catches are inserted in centre of trim panel between dash
panel and monitor housing -arrows-.
– With ignition switched on, connect battery earth wire ⇒ Elec‐
trical system; Rep. gr. 27 .
Tightening torque:
Storage compartment (driver's side) to dash panel: 4 Nm
1.7 Removing storage box from storage
compartment and installing
Removing
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1. Shelves / trim panels 11

Audi A8 2003 Specifications

General

Brand	Audi
Model	A8 2003
Category	Automobile
Language	English