Audi A8 2003 - Separating Driver Side J674 and Front Passenger Side J675 Rear Seat Ventilation Control Unit from Mounting Plate

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.12 Separating driver side -J674- and front
passenger side -J675- rear seat ventila‐
tion control unit from mounting plate
♦ Removing
– Vehicles with centre console extension: Remove the centre
console extension ⇒ page 59 .
– Vehicles with no centre console extension: Remove the centre
section ⇒ page 341 .
– Remove the mounting plate for control units ⇒ page 347 .
To remove the left seat ventilation control unit -4-:
– Prise out the clip -5-.
– Take out the control unit -4-.
To remove the right seat ventilation control unit -3-:
– Prise out the clip -6-.
– Take out the control unit -3-.
♦ Installing
– Press the control unit -3- or -4- into the mounting plate -8-.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
348 Rep. gr.72 - Seat frames