Audi A8 2003 - Seat Belts; Seat Belt Anchorage Points (Block Diagram)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2 Seat belts
2.1 Seat belt anchorage points (block diagram)
1 - Outer floor panel anchorage
point
❑ Removing, Page
⇒ page 107
2 - Three-point seat belt
❑ Removing, Page
⇒ page 107
3 - Belt height adjuster
❑ Removing, Page
⇒ page 109
❑ Always replace belt
height adjuster after belt
tensioner triggering with
belt fastened
4 - Rear three-point seat belt
❑ Removing, Page
⇒ page 109
5 - Third rear three-point seat
belt
❑ Removing, Page
⇒ page 111
6 - Anchorage point: rear outer
floor panel
❑ Removing with fixed
rear seat backrest,
Page ⇒ page 113
❑ Removing with electri‐
cally operated individual
rear seats ⇒ page 114
7 - Centre floor panel anchor‐
age points (buckle)
❑ Removing with fixed
rear seat bench, Page
⇒ page 114
❑ Removing with electrically operated individual rear seats ⇒ page 116
❑ Always replace belt buckle after belt tensioner triggering with belt fastened
8 - Buckle anchorage point
❑ Replacing ⇒ page 116
❑ Replacing with seat occupied sensor for front passenger's airbag deactivation »Country-specific«, front
passenger side only ⇒ page 116
❑ Always replace belt buckle after belt tensioner triggering with belt fastened
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
106 Rep. gr.69 - Passenger protection