Audi A8 2003 - Safety regulations and test methods for pyrotechnic, electrical and mechanical components of the restraint system

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
5 Front centre armrest (split)
Overview
♦ ⇒ „5.1 Removing and installing centre armrest (split)“,
page 84
♦ ⇒ „5.2 Removing and installing lower support (split centre
armrest)“, page 85
♦ ⇒ „5.3 Dismantling and assembling centre armrest (split)“,
page 86
♦ ⇒ „5.4 Removing and installing cover panel for centre armrest
(split)“, page 87
♦ ⇒ „5.5 Removing and installing padding for centre armrest
(split)“, page 87
♦ ⇒ „5.6 Removing and installing split centre armrest storage
compartment“, page 88
♦ ⇒ „5.7 Removing and installing lower cover panel for centre
armrest (split)“, page 88
♦ ⇒ „5.8 Removing and installing trim“, page 89
♦ ⇒ „5.9 Removing and installing storage compartment light“,
page 90
♦ ⇒ „5.10 Separating centre armrest (split)“, page 90
5.1 Removing and installing centre armrest
(split)
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1410-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
84 Rep. gr.68 - Interior equipment