Audi A8 2003 - Removing and Installing Seat Pan

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.3 Removing and installing seat pan
1 - Individual rear seat
2 - Seat pan
♦ Removing
– Move the seat angle ad‐
juster to the top position
and the longitudinal ad‐
juster to the centre posi‐
tion.
– Reach beneath the seat
on the sill panel side and
feel for the lever -3-.
– Press the lever -3- and
pull the seat pan -2- up‐
wards.
– Unplug the connector
beneath the seat pan
-2-.
– Disengage the seat pan
-2- in the direction of
travel from the individual
rear seat -1-.
♦ Installing
– Engage the seat pan
-2- on the left and right
in the individual rear
seat -1- ⇒ page 342
– Press down the seat
pan -2- until it engages
at the front.
3 - Lever
Rear seat pan attachment
Note
The guide -1- (2x) must always be replaced following removal.
On installation, the seat pan must engage at the rear in the guide
-1- on the left and right.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
342 Rep. gr.72 - Seat frames