Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Position the crash sensor -1- on the threaded pins.
– Secure the crash sensor -1- with the nuts -2- (2x).
♦ Tightening torque 9 Nm.
WARNING
There must not be anyone in the vehicle when connecting the
battery.
– With the ignition switched on, connect the battery earth wire
⇒ Electrical system; Rep. gr. 27 .
Note
If the airbag warning lamp -K75- indicates a fault following instal‐
lation, the event recorder must be interrogated, erased and inter‐
rogated again ⇒ Vehicle diagnostic tester.
12.3 Removing and installing rear side airbag
(curtain airbag) crash sensor
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1410-
♦ Removing
WARNING
Heed the safety regulations for pyrotechnic components
⇒ page 94 .
– With the ignition switched on, disconnect the battery earth wire
⇒ Electrical system; Rep. gr. 27 .
– Remove the rear wheel housing trim ⇒ page 258 .
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
12. Servicing airbag crash sensors 169
To Next Page
Loading...
