Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6.18 Removing and installing box for tool kit
and hazard warning triangle
Removing
– Open the box for the tool kit and hazard warning triangle -1-.
– Unclip the covers -2- (5x).
– Use a flat screwdriver to carefully press the tabs -3- upwards
in arrow direction.
– Detach the box for the tool kit and hazard warning triangle.
Installing
Install in reverse order. Pay attention to the following:
♦ Make sure all retainer tabs (5x) are properly engaged.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
268 Rep. gr.70 - Trim, insulation
To Next Page
Loading...
