Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.7 Removing and installing rear outer floor
panel anchorage point
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
– Remove the rear seat bench ⇒ page 333 .
– Remove the rear seat backrest ⇒ page 176 and
⇒ page 334 .
– Unscrew the bolt -2-.
– Disengage the anchorage point -1-.
♦ Installing
– Engage the anchorage point -1- in arrow direction.
– Screw in the bolt -2-.
♦ Tightening torque 55 Nm.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Seat belts 113
To Next Page
Loading...
