Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
12.2 Removing and installing front side air‐
bag crash sensor
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1410-
♦ Removing
WARNING
Heed the safety regulations for pyrotechnic components
⇒ page 94 .
– With the ignition switched on, disconnect the battery earth wire
⇒ Electrical system; Rep. gr. 27 .
– Remove the lower B-pillar trim ⇒ page 256 .
– Unfasten the reel. Complete seat belt removal is not neces‐
sary ⇒ page 107 .
– Unscrew the nuts -2- (2x).
– Release the tab at the yellow connector -1- and unplug the
connector.
♦ Installing
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
168 Rep. gr.69 - Passenger protection
To Next Page
Loading...
