Audi A8 2003 - Removing and Installing Rear Air Distributor and Rear Air Duct (2 and 4-Zone Climate Control)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.22 Removing and installing rear air distrib‐
utor and rear air duct (2 and 4-zone
climate control)
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783/-
1 - Centre console
2 - Bolts (4x), 2 Nm
3 - Centre console air distribu‐
tor
2-zone climate control
❑ Rear left vent warm air
and cold air flap control
motor ( -V220- ) -4-
4-zone climate control
❑ Rear left vent warm air
and cold air flap control
motor ( -V220- ) -4-
❑ Rear right vent warm air
and cold air flap control
motor ( -V221- ) -5-
❑ Rear left centre console
temperature sensor ( -
G311- ) -7-
❑ Rear right centre con‐
sole temperature sen‐
sor ( -G312- ) -6-
♦ Removing
Note
♦ Before unplugging connectors,
mark assignment to
♦ Rear left/right vent warm air and
cold air flap control motors and
♦ Rear left/right centre console
temperature sensors.
– Remove centre console
⇒ page 19 .
– Remove bolts -8- and
-9- (4x).
– Pull rear left -10- and rear right -11- air ducts out of centre console air distributor -3-.
Vehicles with 2-zone climate control
– Unplug electrical connectors at rear left vent warm air and cold air flap control motor ( -V220- ).
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
2. Removing and installing centre console without extension 45