Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
If the airbag warning lamp -K75- in‐
dicates a fault following installation,
the event recorder must be interro‐
gated, erased and interrogated
again ⇒ Vehicle diagnostic tester.
5 - Bolt
❑ Tightening torque 7.5 Nm.
6 - Side airbag connector
7 - Earth cable
8 - Side fastening strips (2x)
Unplugging side airbag connector
– Unfasten the securing clip -1-.
– Unplug the connector -2-.
6.2 Removing and installing rear side airbag
Special tools and workshop equipment required
♦ Fastening tool -VAS 6138-
♦ Fastening tool -VAS 6273-
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
6. Servicing side airbags 137
To Next Page
Loading...
