Audi A8 2003 - Removing and Installing LED for Operation Indicator

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Pull off the rotary knob -1- for the thermostat.
Note
♦ If stiff, use universal pliers to pull off the rotary knob.
♦ Wrap a cloth around the jaws of the pliers so as not to damage
the rotary knob.
– Unscrew the nut -1- and screw out the bolts -arrows-.
– Detach the trim -2- with the hinged cover for the refrigerator
box.
– Unplug the connectors -1- and -4-.
– Take the contact switch -arrow- for the refrigerator box interior
light out of the trim.
Installing
Install in reverse order, paying attention to the following:
Note
Re-attach all cable ties in the same locations on installation.
Tightening torques
Component Nm
Thermostat to trim 12
Trim to housing 1.5
1.5 Removing and installing LED for opera‐
tion indicator
Removing
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
388 Rep. gr.76 - Gas, water, electricity