Audi A8 2003 - Removing and Installing Mirror Adjustment Switch; Removing and Installing Interior Door Handle with Central Locking System Switch

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.10 Removing and installing mirror adjust‐
ment switch
♦ Removing
– Remove the door trim ⇒ page 176 .
– Remove the insulation ⇒ page 176 and ⇒ page 181 .
– Remove the armrest ⇒ page 182 .
– Dismantle the armrest ⇒ page 183 .
– Use a screwdriver to prise out the mirror adjustment switch
-1-.
– Unplug the connector -2-.
♦ Installing
– Install the mirror adjustment switch -1- in the reverse order of
removal.
1.11 Removing and installing interior door
handle with central locking system
switch
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783/-
♦ Removing
– Remove the door trim ⇒ page 176 .
– Unplug the connector -1-.
– Unplug the connector -2-.
– Unscrew the bolts -4- (2x).
♦ Tightening torque 2 Nm.
– Take out the interior door handle on the front side of the door
trim.
♦ Installing
– Make sure the cable of the connector -2- is positioned behind
the holder -3-.
– Install the interior door handle in the reverse order of removal.
Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
184 Rep. gr.70 - Trim, insulation